IG L1/S 100 Cavity Wall Lintel
This product is currently only available in our local delivery area: AL1, AL10, AL2, AL3, AL4, AL5, AL6, AL7, AL8, AL9, CM19, EN1, EN10, EN11, EN2, EN3, EN4, EN5, EN6, EN7, EN8, EN9, HA3, HA7, HA8, HP1, HP2, HP3, HP4, LU1, LU2, N10, N11, N12, N13, N14, N18, N2, N20, N21, N22, N3, N4, N9, NW4, NW7, NW9, SG10, SG11, SG12, SG13, SG14, SG2, SG3, SG4, SG9, WD1, WD17, WD18, WD19, WD2, WD23, WD24, WD25, WD4, WD5, WD6, WD7
The IG L1/S 100 is a standard duty lintel for cavity walls of between 90 and 105mm.
Manufactured from high quality grade galvanised steel to BS EN 10346:2009 DX51D standard plus Z600.
Steel Lintels Installation Guide
- Steel Lintels should be installed with a minimum end bearing of 150mm, bedded on mortar and levelled along its length and across its width.
- The masonry above the lintel should be built in accordance with BS EN 1996-2:2006.
- Raise the inner and outer leaves simultaneously to avoid excessive eccentricity of loading, with a maximum height difference of 225mm (Masonry should be laid on a mortar bed and all perpendicular joints should be filled.)
- Allow the mortar to cure before applying floor or roof loads (Temporary propping beneath a steel lintel is practised to facilitate speed of construction).
- The NHBC recommend a damp proof course (DPC) or cavity tray should be installed over all openings in external cavity walls.
- When installing concrete floor units or other heavy components above a lintel, care should be taken to avoid shock loading and floor units should not be dragged into position. Masonry immediately above the lintel should be allowed to cure.
- Point loads should not be applied directly onto lintel flanges. Steel Lintels should have a minimum of masonry 150mm high between the flange and the application level of any form of loading. Consult IG’s technical department if applying a point load above lintels.
- The external lintel flange must project beyond the window/door frame and it is recommended that a flexible sealing compound is used between the underside of the lintel flange and the frame.
- When the underside of a lintel is exposed, its appearance can be enhanced by the addition of lintel soffit cladding.
- Do not cut lintels to length or modify them in any way without consulting an IG engineer.